Crank handle replacement

[ruffles19]

The start handle that came with my old dumper's PH2 hand crank engine only survived a few moments before the pin bent and snapped, probably from cranking a bit too hard. It looked like a homemade job , made from steel bar with a pin through the end to lock into the lobes. Im now on the hunt for a sturdier replacement but haven't had much luck so far, any leads?

 

[Panees]

You might have better luck checking with small engine repair shops since they sometimes keep old crank parts around. If nothing turns up, a local fabricator could easily make you one that will outlast the engine.